PBE-5AC-400 WIRELESS BRIDGE,OUTDOOR 5GHz 25DBI

$0.00
Ex Tax: $0.00
Product Code: PBE-5AC-400
Stock Instock

Overview

PBE-5AC-400 from UBIQUITI networks is one of the most convenient Power Beam ac model available in the market. PBE-5AC-400 will definitely satisfy the need of the customer requiring a Pow...

PBE-5AC-400 from UBIQUITI networks is one of the most convenient Power Beam ac model available in the market. PBE-5AC-400 will definitely satisfy the need of the customer requiring a Power Beam ac.PBE-5AC-400 comes along with the following:

  • 1. Dish Reflector.
  • 2. Antenna feed.
  • 3. Rear Housing.
  • 4. Dish Bracket.
  • 5. Pole Clamp.
  • 6. U- bolt.
  • 7. Flange nuts (M6, 2 pieces).
  • 8. Washers (M6, 2 pieces).
  • 9. Mounting Bracket with Gigabit PoE (24 V, o.5 A).
  • 10. Power Cord.

Directional outdoor coverage is provided by the Power Beam model, PBE-5AC-400, mounted outdoors with the installation of Dish Reflector. If the Dish Reflector is not installed, an outdoor to indoor coverage will be provided with the help of 3 dBi Antenna feed only.

For the installation of PBE-5AC-400, the tabs of the Dish Bracket should be aligned and inserted into the slots of the Dish Reflector. The Dish Bracket should be rotated anti-clockwise till the tabs are locked in place. The Alignment pins of the rear housing should be lined up with the alignment holes of the Dish Bracket. The pins should be pushed and inserted till they lock into place. The sides of the Cable door must be pushed in and then detached from the Rear Housing. The Antenna Feed should be attached and the Ethernet cable should be connected. The pole clamp should be slid onto the Dish Bracket. The U-Bolt should be inserted into the Pole Clamp and Dish Bracket. Each end of the U-Bolt should be secured with a Flange nut. The Ethernet Cable from the Power Beam Ethernet port should be connected to the POE port of the Gigabit PoE adapter. An Ethernet cable from the LAN should be connected to the adapter's LAN port. The Power cord should be connected to the adapter's power port. The other end of the Power cord should be connected to a power outlet. Thus, the installation procedure of PBE-5AC-400 is completed. The Mounting of PoE Adapter is optional.





Write a review

Note: HTML is not translated!

Rating Bad           Good
Continue