ถ้าคุณสนใจสินค้า คุณสามารถกดขอใบเสนอราคา เราจะติดต่อกลับโดยเร็วที่สุด --- If you are interested. You can request a quote. We will get back to you as soon as possible.

AM-5G20-90 5.15-5.85GHZ HI-GAIN BASE STATION ANTENNA,DUAL-POL 90-DEGREE 20DBI

$0.00
Ex Tax: $0.00
Product Code: AM-5G20-90
Stock Instock

Overview

AM-5G20-90 is the sector antenna by airMax which gives a frequency of 5 GHz. The dimensions of AM-5G20-90 are 700 x 135 x 73 mm. Let's have a look at the items associated with this secto...
AM-5G20-90 is the sector antenna by airMax which gives a frequency of 5 GHz. The dimensions of AM-5G20-90 are 700 x 135 x 73 mm. Let's have a look at the items associated with this sector antenna. The Package of AM-5G20-90 contains:
  • 1. Antenna.
  • 2. Protective Shroud.
  • 3. U-Brackets (2 pieces).
  • 4. Pole Brackets (2 pieces).
  • 5. Pole Clamps (2 pieces).
  • 6. Carriage bolts (M8 x 135, 4 pieces).
  • 7. Serrated Flange bolts (M8 X 20, 4 pieces).
  • 8. Serrated Flange nuts (M8, 8 pieces).
  • 9. RF cables (2 pieces).
To install the AM-5G20-90 sector cable, some procedures must be followed. Now to install the hardware, the RF cables should be attached to the connectors. The connectors on the rocket are labeled Chain 0 and Chain 1 for the convenience of the users. The Rocket Mount Board should be attached to the Rocket. On the rear part of the rocket, the mounting tabs should be aligned with the 4 mounting slots present on the bracket. Till the rocket locks into place, slide it down.
The RF connectors present on the antenna must be connected to the other ends of the RF cables. The protective Shroud should be slid down as well till it locks onto the Rocket Mount Bracket. Further, the U- Brackets should be attached to the antenna. 2 Carriage bolts should be inserted into each Pole Bracket. Each Pole Bracket should be attached to each U- Bracket using 2 Serrated Flange Bolts. The bolts should be tightened using hands. For mounting the AM-5G20-90 sector antenna to the pole, a pole clamp should be slid over each pair of carriage bolts. Each Pole clamp should be secured with 2 Serrated Flange Nuts. Now to adjust the elevation angle of the AM-5G20-90 sector antenna, slide it to the tilt you desired. All nuts and bolts should be tightened to 25 N-m approx. Thus, the installation is completed by these procedures.
AM-5G20-90 by airMAX is the sector antenna which one could rely on for use.






Write a review

Note: HTML is not translated!

Rating Bad           Good
Continue